ST 68517031 Spring Package 30-170*/ 10-60-80 TOYOTA GR YARIS 2020+
Quantity:
This item is considered special order and is not available for immediate pickup or dispatch. Price and ETA may vary. Please note that no returns, cancellations, or refunds allowed on special orders.
Pickup available at ATOMIC-SHOP UA
Usually ready in 1 hour
ST 68517031 Spring Package 30-170*/ 10-60-80 TOYOTA GR YARIS 2020+
ATOMIC-SHOP UA
Pickup available, usually ready in 1 hour
вул. Набережно-Лугова, 29
Київ
02000
Ukraine
ST SPRING PACKAGE 30-170*/ 10-60-80
PART-NO.: 68517031
Please observe the conditions and instructions for this product.
Spring Rate (Racing Spring): 30
Inner Diameter (Racing Spring): 61
Length (Racing Spring): 170
Valid Spring Travel (Racing Spring): 110
Wire Diameter (Racing Spring): 8,25
Approval: without
Content of delivery: 2 x race spring, 2 x pre-load spring including intermediate ring
Car type: TOYOTA YARIS (_P21_, _PA1_, _PH1_) 02/2020- 1.6 GR 4WD (GXPA16) - 200kW - 1618ccm - 3 cyl. - All-wheel Drive
ST additional racing spring kits for coilover kits
With the additional ST racing spring kits we offer to individually adapt the setup of your ST coilover kit to your needs.
Our additional racing spring kits are available in different spring rates and lengths, therefore allowing a more sporty or even more comfortable suspension setup.
Spring markings – what you should know
Example: FA 70-170*
FA = front axle (RA = rear axle), 70 = spring rate, 170 = spring length, * = high-strength racing spring made out of a material with higher load capacity
What does spring rate and spring length mean?Spring rate:
The spring rate shows, how much power (in kg) is needed to compress the spring by 10mm. The higher the spring rate, the harder the spring itself is. Example: At a spring rate of 70, the spring will be compressed by 10mm at a load of 70kg.
Lower spring rate = less setup frequency, the vehicle is getting more comfortable and lower at payload.
Higher spring rate = higher setup frequency, the vehicle is getting sportier and less low at payload.
Spring length:
Information on the length of the spring in mm
Longer spring = less possible lowering
Shorter spring = more possible lowering
Die optionalen ST Federpakete werden als Zusatzartikel geliefert. Durch die Verwendung dieser, vom Teilegutachten abweichenden, optionalen ST Federpakete in Kombination mit unserem ST XTA Gewindefahrwerk erlischt nach §19.2 StVZO die Betriebserlaubnis. Diese kann durch eine Einzelabnahme nach §21 StVZO wiedererlangt werden. Als Arbeitsgrundlage für den Sachverständigen werden Federdatenblätter zur Verfügung gestellt. Diese beinhalten die Information, dass die Federn Dauerbetriebsfest sind. Letztendlich obliegt es aber immer im Ermessen des Sachverständigen, ob er die Eintragung vornimmt.
Zur Montage der optionalen Federpakete müssen die Unibal-Stützlager demontiert werden. Dazu empfehlen wir die Verwendung der Domlagernuss 68510179