AQUAMIST

AQUAMIST: The British Gold Standard of Water Injection

In the niche world of water/methanol injection, there is AQUAMIST, and then there is everyone else. Founded by Richard Lamb in the UK, this company pioneered modern injection technology in the 1990s specifically for WRC (World Rally Championship) factory teams. While others focus on making cheap kits for the masses, AQUAMIST focuses on precision, response, and fail-safe reliability.

ATOMIC-SHOP is proud to supply the legendary HFS Series (HFS-3, HFS-4). These systems are chosen by tuners who build high-value engines and cannot afford a failure. If you are pushing your turbo setup to the absolute limit and need guaranteed knock suppression, AQUAMIST is the only logical choice.

The Physics: Why Inject Water?

Injecting a water/methanol mixture solves the two biggest limitations of a turbocharged engine:

• Chemical Intercooling: Water has a massive "latent heat of vaporization." When a fine mist is sprayed into the hot intake charge, it flash-evaporates, absorbing heat energy instantly. This can drop Intake Air Temperatures (IATs) by 40-60°C, creating a denser, oxygen-rich charge.
• Octane Enhancement: Methanol is a high-octane fuel. By adding it to the combustion chamber, you effectively raise the knock threshold of your pump gas. This allows the tuner to advance ignition timing and run higher boost levels safely, unlocking horsepower that was previously limited by detonation.

The Game Changer: PWM Valve vs. Pump Speed

This is the technical differentiator. Most competitor kits control flow by varying the voltage to the pump (speeding it up or slowing it down). This is an "agricultural" method—pumps are heavy and slow to react. They lag when you hit the throttle and dribble when you let off.

The AQUAMIST Way: The pump in an HFS system runs at a constant 160 psi (11 bar) bypass mode. Flow is controlled by a Fast Acting Valve (FAV) placed just before the jet. This valve pulses (PWM) thousands of times per minute, mirroring the operation of a fuel injector. It offers instant on/off control and perfect atomization.

True Failsafe: Saving Your Engine

If you tune your car for methanol, you become dependent on it. If the tank runs dry or a jet clogs, your engine could be destroyed in seconds. AQUAMIST offers the best protection in the industry.

Every HFS kit includes a dedicated Turbine Flow Sensor. It monitors the actual volume of fluid being injected. You define a "safe window" of flow. If the flow drops below or spikes above this window, the AQUAMIST controller instantly cuts the boost (by interrupting the wastegate solenoid or switching ECU maps), saving your engine before damage occurs.

Frequently Asked Questions (FAQ)

HFS-3 vs HFS-4: Which one do I need?

The HFS-3 is designed for Port Injection engines. It reads the duty cycle from a standard fuel injector. The HFS-4 is the flagship model designed specifically for Direct Injection (DI) engines (like VW TSI, Mazda DISI, BMW N54/N55). It has advanced signal processing to handle the complex, high-voltage signals of DI injectors, ensuring seamless integration.

What fluid should I use?

We recommend a 50/50 mix of distilled water and pure methanol (M1). This ratio provides the best balance of cooling (water) and octane boosting (methanol), while remaining relatively safe to handle. Do not use windshield washer fluid with additives or glycol, as these can clog the precision filters and flow sensors of the AQUAMIST system.

Where should I mount the nozzle?

For most applications, a single jet placed 6-12 inches before the throttle body (or intake manifold) is sufficient. This gives the mist time to evaporate and cool the charge air. For extreme builds or uneven manifolds, AQUAMIST offers Direct Port bundles (4 or 6 jets) to inject fluid directly into each intake runner, ensuring perfect cylinder distribution.