ST 68517007 Spring Package 30-200 (2 X RACE SPRING) TOYOTA GR YARIS 2020+

ST SPRING PACKAGE 30-200*

PART-NO.: 68517007

 Please observe the conditions and instructions for this product.

Spring Rate (Racing Spring): 30

Inner Diameter (Racing Spring): 61

Length (Racing Spring): 200

Valid Spring Travel (Racing Spring): 128

Wire Diameter (Racing Spring): 8,75

Approval: without

Content of delivery: 2 x race spring

Car type: TOYOTA YARIS (_P21_, _PA1_, _PH1_) 02/2020- 1.6 GR 4WD (GXPA16) - 200kW - 1618ccm - 3 cyl. - All-wheel Drive

 

 

ST additional racing spring kits for coilover kits

 

With the additional ST racing spring kits we offer to individually adapt the setup of your ST coilover kit to your needs.

Our additional racing spring kits are available in different spring rates and lengths, therefore allowing a more sporty or even more comfortable suspension setup.

 

Spring markings – what you should know

Example: FA 70-170*

FA = front axle (RA = rear axle), 70 = spring rate, 170 = spring length, * = high-strength racing spring made out of a material with higher load capacity

 

What does spring rate and spring length mean?Spring rate:

The spring rate shows, how much power (in kg) is needed to compress the spring by 10mm. The higher the spring rate, the harder the spring itself is. Example: At a spring rate of 70, the spring will be compressed by 10mm at a load of 70kg.

Lower spring rate = less setup frequency, the vehicle is getting more comfortable and lower at payload.

Higher spring rate = higher setup frequency, the vehicle is getting sportier and less low at payload.

 

Spring length:

Information on the length of the spring in mm

Longer spring = less possible lowering

Shorter spring = more possible lowering

 

Die optionalen ST Federpakete werden als Zusatzartikel geliefert. Durch die Verwendung dieser, vom Teilegutachten abweichenden, optionalen ST Federpakete in Kombination mit unserem ST XTA Gewindefahrwerk erlischt nach §19.2 StVZO die Betriebserlaubnis. Diese kann durch eine Einzelabnahme nach §21 StVZO wiedererlangt werden. Als Arbeitsgrundlage für den Sachverständigen werden Federdatenblätter zur Verfügung gestellt. Diese beinhalten die Information, dass die Federn Dauerbetriebsfest sind. Letztendlich obliegt es aber immer im Ermessen des Sachverständigen, ob er die Eintragung vornimmt.

Zur Montage der optionalen Federpakete müssen die Unibal-Stützlager demontiert werden. Dazu empfehlen wir die Verwendung der Domlagernuss 68510179